SCM

Discussion Forums: help

Monitor Forum | Start New Thread Start New Thread

 

RE: how to display intersection of plane and mesh on an image [ reply ]
By: Vincent Daanen on 2016-02-26 08:07
[forum:3546]
Hello Nicolas,

I gave a try to mesh clipping but it does not allow me to see what I want.

the good tool whould vtkCutter.. maybe for the next release ...


V

RE: how to display intersection of plane and mesh on an image [ reply ]
By: Nicolas SAUBAT on 2016-02-24 11:18
[forum:3545]
Hello Vincent,

To my knowledge, there is no "easy" direct way to do this.
Nevertheless, have you tried the Mesh Clipping action? This clips a given mesh into pieces according to a plane that you can move.
Once clipped, you might manually pick the point at the frontier of your mesh ...

Does this help you?

Nicolas.

how to display intersection of plane and mesh on an image [ reply ]
By: Vincent Daanen on 2016-02-17 10:15
[forum:3529]
Hi,

I want to use camitk to display mesh with 3D image.
I could load the 3D image, the mesh but I can't figure out how I can display the edges resulting of the intersection of the mesh with the image plan over the image.

Is there a way to do this easily ?

V

   
Powered By FusionForge